MMU2_Festo_Holder_M10-Plus22mm.stl (3544316)
Item Preview
There Is No Preview Available For This Item
This item does not appear to have any files that can be experienced on Archive.org.
Show all files
I implemented pmeyer's "Prusa Research MMU2 improved roller"
https://www.thingiverse.com/thing:3113520/
...which gives much lower rolling resistance to spools compared to the stock Prusa spool trays.
However, the PTFE fitting was too low and the filament would rub the roller, so I remixed s_kohl's "MMU2 Festo Holder 1-piece M6 & M10"
https://www.thingiverse.com/thing:3097104
(just the M10) ...to raise the holes by 22mm, putting the filament at the correct height.
https://www.thingiverse.com/thing:3113520/
...which gives much lower rolling resistance to spools compared to the stock Prusa spool trays.
However, the PTFE fitting was too low and the filament would rub the roller, so I remixed s_kohl's "MMU2 Festo Holder 1-piece M6 & M10"
https://www.thingiverse.com/thing:3097104
(just the M10) ...to raise the holes by 22mm, putting the filament at the correct height.
Reviews
There are no reviews yet. Be the first one to
write a review.
