made to work along my GrabHole QR adapter: https://www.thingiverse.com/thing:4510106
This clamp offers a strong support for anamorphic lenses. The diameter is roughly 70mm and therefore works with many many lenses. I successfully tested the following scopes: - Kowa Prominar 16H/8Z, B&H - Sankor Type-5e - Schneider Kreuznach Cinelux ES - Sankor CompactCinemascope/AnamoPrime - Iscomorphot 16/2x ISCO Ultra-Star lenses should work as well, as a variety of other scopes
This build needs an M3 nut, washer and screw (~15mm). Attach as close to the front of the scope as possible.
I made three versions for different rod-clamps. 40mm is the width of my generic china brackets, but I also did it for Neewer and SmallRig blocks. The longhole isn't as long as this support was made for common LWS heights with a bit of wiggle room :)
Prints well without support. Infill should be at least 20-25%.
**I found this clamp to be very sturdy; however, 3D printing has many variables that differ in every setup. Only use if you are comfortable with these kinda setups, I don't take any responsibility for yours.**