My table is too small for my large intros pro to stay there full time, but want easy access so I made a sand to sit on the floor next to the computer easy to grab and put back.
There is enough tolerance that you can add a thin layer of padding (less than 1mm for each side), but otherwise works well without it.
Holds the large version in vertical position very well, so will hold other version just as well. I printed it in PETG but should work well in PLA
If you want to use it for other stuff, I made one without Wacom text width of the holder opening is 14.5mm, but taking into account tolerance, would fit something that is 12 to 14mm thick stand is 200mm long width of the platform is about 90mm long side is about 80mm tall short side is about 50mm tall